Electrical Testing & Commissioning Training Course

Module 1: Introduction and International Standards

• Overview of electrical systems: generation, transmission, and distribution

• Role and responsibilities in testing and commissioning

• International and local standards: IEC, BS, IEEE, NFPA

• Compliance with safety and environmental regulations

• Risk assessment and method statement preparation

Module 2: Testing Equipment and Measurement Principles

• Identification of electrical testing instruments and calibration techniques

• Measurement of voltage, current, resistance, capacitance, insulation resistance

• Safe use of instruments and interpreting test readings

• Understanding measurement uncertainty and precision

Module 3: Pre-Commissioning and Inspection

• Visual, mechanical, and continuity checks

• Insulation resistance testing and ambient condition analysis

• Earth resistance measurement and grounding verification

• Cable terminations, connections, and torque setting inspections

Module 4: High Potential (Hi-Pot) and Dielectric Testing

• Purpose and safety of dielectric (Hi-Pot) testing

• Cable, transformer, and switchgear testing under dielectric stress

• Acceptance criteria for insulation and high-voltage systems

• Identifying insulation breakdowns and partial discharge

Module 5: Relay and Protection System Testing

• Fundamentals of electrical protection systems

• Types of relays: overcurrent, differential, distance, earth fault

• Primary and secondary injection testing procedures

• Relay coordination and trip circuit verification

Module 6: Power Quality and System Performance

• Understanding harmonics, power factor, voltage fluctuations, and frequency variations

• Load balancing, voltage regulation, and system stability

• Power quality analyzers and diagnostic tools

• Corrective actions for improving efficiency and reliability

Module 7: Functional and Commissioning Tests

• Functional verification of switchgear, transformers, and motor control systems

• Generator synchronization procedures

• Control and protection system testing

• Emergency stop and interlock verification

• Commissioning sequences and start-up protocols

Module 8: Troubleshooting and Fault Analysis

• Common electrical faults: short circuits, insulation degradation, earth leakage

• Root cause analysis and diagnostic procedures

• Use of modern testing equipment in fault detection

• Developing corrective maintenance strategies

Module 9: Documentation, Reporting, and Handover

• Preparing professional test reports and commissioning documents

• Managing non-conformities and corrective actions

• Certification and compliance documentation

• Final client handover and commissioning punch-list closure

Module 10: Safety, Environment, and Best Practices

• Safety procedures, PPE use, and Lock-out/Tag-out (LOTO)

• Managing live testing and electrical hazards

• Environmental protection and waste management in electrical testing

• Sustainable commissioning practices and continuous improvement